Modes
 When LaTeX is processing your input text, it is always in one of three
 modes:
  - Paragraph mode
  
 - Math mode
  
 - Left-to-right mode, called LR mode for short
 
 LaTeX  changes  mode only when  it goes  up or down  a staircase  to a
 different  level, though not all level changes  produce  mode changes.
 Mode changes occur only when entering  or leaving  an environment,  or
 when  LaTeX  is processing  the  argument  of  certain  text-producing
 commands. 
Paragraph mode
 Paragraph  mode  is the most  common;  it's  the one LaTeX  is in when
 processing  ordinary  text.  In that mode, LaTeX breaks your text into
 lines and breaks  the lines  into pages. 
 There
 are also several text-producing commands and environments for making a
 box that put LaTeX  in paragraph  mode.   The box made by one of these
 commands  or environments  will be called a 
 parbox.   When LaTeX is in
 paragraph mode while making a box, it is said to be in inner paragraph
 mode.  The normal  paragraph  mode, in which LaTeX starts  out, is called
 outer paragraph mode. 
Math mode
 
 LaTeX  is in math mode when it's generating a mathematical formula. It is
 in math mode in the math, 
 displaymath, equation,
 and  eqnarray environments.
 In math mode letters are assumed to be math symbols and spaced accordingly.
 Spaces in the input are ignored, except that spaces may be needed to 
 delineate the end of commands.
LR mode
 In LR mode, as in paragraph
 mode, LaTeX considers  the output that it produces  to be a string  of
 words with spaces between them. In LR mode, unlike paragraph and math modes,
 spaces are not ignored; an input space creates an output space. 
 However, unlike paragraph mode, LaTeX
 keeps going from left to right; it never starts a new line in LR mode. 
 Even  if you put a hundred  words  into  an 
 \mbox,  LaTeX  would  keep
 typesetting  them from left to right  inside  a single  box,  and then
 complain because the resulting box was too wide to fit on the line.
 LaTeX is in LR mode when it starts making a box with an 
 \mbox command. 
 You can get it to enter a different mode inside the box - for example,
 you can make it enter  math mode to put a formula  in the box.  
Also see Math Formulas
Go to LaTeX Table of Contents
Revised by Sheldon Green, agxsg@giss.nasa.gov, 31 May 1995.